Amp #2 Populating the Chassis.

Amp #2
Over the last few days I've been able to get the rest of the holes cut and enlarged in the chassis.
Tonight I was able to get most of the front and back panel components in place. For the Rectifier and the Power Tubes I found these Gold plated bottom mount sockets. I like them better than top mounts. For the preamp tubes I went with top mounts because they need the housings and a bottom mount doesn't make sense for those sockets.



Here is the Back panel with the Components Listed Left to Right.
1/4" Jack Preamp-Cabinet Emulating (post output transformer)
Preamp Volume Control
1/4" Jack Preamp - Clean
Preamp Switch Cab-Off-Clean
Speaker Attenuation Switch On-Off
Speaker 1
Speaker 2
Tremolo Foot Switch
Speaker Impedance
Voltage Selector
AC IN
Fuse


Front Panel Components Left to Right
Pilot Lamp
Power Switch On-Off
Standby Switch On-Off
Tremolo Speed
Tremolo Intensity
1/4" Input Jack Hi Tremolo Channel
1/4" Input Jack Low Tremolo Channel
Tone
Volume
1/4" Input Jack Hi
1/4" Input Jack Low